18
Daisy-chain Connection
NOTES:
Use the RS-232C cross cable to connect the computer to this Display.
The computer shown is for example purposes only.
A DVI cable and IR cable are attached.
When using daisy chain, set the “TILING” menu option in the OSD “CONFIGURATION2 menu”. (see page 27)
Up to 10 displays can be connected with a daisy chain, but the number of the connected displays may be limited by a cable
signal or equipment to use.
HDCP can be supported for up to 8 displays for a daisy chain.
Display No.1 Display No.3Display No.2
[RS-232C]
Display No.1 Display No.3Display No.2
[DVI]
With the optional “Remote Control Kit” (TY-RM50VW), you can specify the Display ID for daisy-chain connection.
External
IR Receiver
Display No.2Display No.1
Use the “connector cable of remote control”
supplied with TH-55LFV5 series
to connect next display.