Service Mode
CAT (Computer Aided Test) Mode
IIC Mode
Select the IIC mode by Up/Down buton on the remote control at the front page of CAT mode and then press the Action
button on the remote control.
1. Select the alignment Subject by Up/Down buttons
on remote control.
2. Select the alignment Item by Left/Right buttons
on the remote control.
3. Adjust optimum setting by Volume Up/Down buttons
on the remote control.
4. The data is memorized when press the R button
on the remote control or change the alignment
Subject (or Items).
Subject and Item are mentioned on “IIC mode structure”.
To exit the IIC mode, press the R button on remote control.
CAT panel sys. 8.2
IIC Mode
CD Mode
NW Mode
SD Mode
MS Mode
ID mode
Mode Function Access Button
IIC Mode Service Alignment Action
CD (Complete
Diagnostic)
Software version
information EEPROM edit
Mute
more than 3 seconds
NW Mode LAN terminal check Action
SD (Status Display) MTBF parameter Action
MS Mode Market Select Mute
more than 3 seconds
ID Mode LSI Check Mute
more than 3 seconds
Y 525/480)/60p
16:9 STANDARD Mid
LCD W/B Adj.
R Drive
FE FE
CAT mode menu
Remote Control
MUTE
VOL Up/Down
Up/Down
R
Left/Right
CTION
RECALL
How to access the CAT mode.
OSD
Subject
Item
New data
Original data
How to access the CAT mode.
Method A Main unit + remote control operation
Press and hold the button on the right side of the unit and press
the RECALL button on the remote kontrol 3 times quickly within 2
seconds, this will placet he unit into the CAT mode.
Method B Remote control operation only
1. Set OFF timer except fot [0] minute by OFF TIMER button.
(30 minutes, 60 minutes, 90 minutes)
2. Set the volume level of sound to 0 by VOL down button / -button.
3. Set the RECALL button more than 3 seconds before a volume
display disappears.
To exit CAT mode, turn the power off by main unit or a remote control.
To Next Page
Loading...
