Panasonic TH-65PF20U - Removal of Plasma Display Panel

28
TH-65PF20U
Note: when fixing Fixed Angle (upper, bottom, left,
right)
• Firstly (1-2-3) in order.
Note: when Front Glass is exchanged
• Paste the Front Glass Sponges in order along each
Fixed Angles left and right, upper and bottom.
Note
• The sponges are parts which cannot be recycled. Please
use the new article when you exchange the Front Glass.
9.20.2. Removal of V1-Board and V2-Board
1. Remove 20 screws ( ) and then remove the Fixed Angle
(left, right, upper, bottom).
2. (Refer to remove of Front Glass).
Remove the Front Glass.
3. Remove 1 screw (D).
4. Disconnect the connector (V11) and then remove V1-
Board.
5. Remove 3 hooks and then remove the Power Button and
Power Button Spring.
6. Disconnect the connector (V22) and then remove V2-
Board.
7. Remove 2 hooks and then remove the 5 Key Button from
V2-Board.
9.20.3. Removal of Cabinet Assy
1. Remove the Front Glass.
(Refer to Removal of Front Glass)
2. Remove V1-Board and V2-Board.
(Refer to Removal of V1-Board and V2-Board)
3. Remove the LED Panel and Remote Sensor Panel.
9.21. Removal of Plasma Display
Panel
The C1,C2,C3 Boards are connected with the plasma dis-
play panel for the repair.
1. Disconnect the Fan Relay Connectors.
2. Remove 8 screws and then remove the Fan.
3. Disconnect the connectors (DS13, P9).
4. Remove the flexible cable from the connector (DS1).