84
Wireless LAN
4 Enter the profile name and wireless network name (SSID), and make other necessary
changes, then click [OK].
5 Select the profile you set and click [Activate].
6 Click .
NOTE
z You need to set the profile for each user.
z The settings depend on the network environment. For further information, ask the system administrator or the person
in charge of the network.
z <For model with Intel
®
Centrino
®
Advanced-N 6205>
For further information of Intel
®
PROSet/Wireless Software, refer to [Help] in the menu bar.
z <For model with Atheros AR928X>
For further information of Atheros, click [Help] - [Atheros Client Utility Help] in the menu bar.
1 Click on the notification area and click or .
2 Click [802.11a Enabled] or [802.11a Disabled].
z A standard user needs to enter an administrator password.
NOTE
z In some countries, communication using IEEE802.11a (5 GHz wireless LAN) standard is restricted by law.
z The Wireless Switch Utility icon ( or ) indicates the on/off status of wireless LAN and/or wireless WAN, not the
setting of IEEE802.11a.
z If IEEE802.11a is enabled or disabled while the computer is connected to an IEEE802.11b/g access point, the connec-
tion will be temporarily interrupted.
z <Only for model with Intel
®
Centrino
®
Advanced-N 6205>
You can also change the IEEE802.11a setting in [Device Manager].
A Click (Start) - [Computer] - [System properties] - [Device Manager].
z A standard user needs to enter an administrator password.
B Double-click [Network adapters] and double-click [Intel(R) Centrino(R) Advanced-N 6205].
Enabling/Disabling the Wireless LAN Standard IEEE802.11a (802.11a)
To Next Page
Loading...
