107
Hard Disk Data Erase Utility
If the password is requested, enter the Supervisor Password.
6 Set the Product Recovery DVD-ROM into the CD/DVD drive.
7 Select the [Exit] menu, then select [TEAC DV-W28XXX ] in [Boot Override].
8 Press
Enter
.
The computer restarts.
If [Enter Password] is displayed during the following procedures, input the Supervisor Password or the User
Password.
9 Click [Erase the whole data on the Hard Disk for security] and click [Next].
10 At the confirmation message, click [YES].
11 Click [Continue].
12 Click [Continue] again.
13 Click [YES].
Erasing the hard disk data starts.
14 After erasing is completed, remove the Product Recovery DVD-ROM and click [OK].
9 Press
2
to execute [2. [Erase HDD]].
To cancel this operation, press
0
.
10 At the confirmation message, press
Y
.
11 When [<<< Start menu >>>] is displayed, press
Enter
.
The approximate time required for erasing data will be displayed.
12 Press
Space
.
At the confirmation message, press
Enter
.
The hard disk erase process starts. When the operation is completed, the [Hard disk data has been deleted] mes-
sage will appear. If a problem has occurred during the operation, an error message will appear.
To cancel partway, press
Ctrl
+
C
. The data erasure will be up to that point.
13 Remove the Product Recovery DVD-ROM, and then press any key to turn off the com-
puter.
To Next Page
Loading...
