72
LAN
NOTE
With this function enabled, power is consumed even if the computer is in sleep
*1
, hibernation, or powered off. Be sure
to use the AC adaptor.
Even when a password is set in the Setup Utility and [Password On Boot] or [Password On Resume] is set to
[Enabled], entering the password is unnecessary for turning on or resuming the computer.
Connect the AC adaptor.
The Power On by LAN function is off under the following conditions:
• When you turn the computer off by sliding the power switch for 4 seconds or longer (e.g., after a hung-up).
• When you reattach the AC adaptor and battery pack to the computer after removing them.
The screen remains dark when the computer resumes from sleep
*1
. The previous screen display will be restored when
you touch the keyboard, touch pad or touchscreen (only for model with touchscreen).
*1
Windows XP: standby
Enabling the Power On by LAN function
The computer automatically turns from off to on when the computer is accessed from the network server via the internal LAN
port.
1
Select [Allow] in [Power On by LAN] in the [Advanced] menu of the Setup Utility (
page 91).
2 In [Caution], press
Enter
.
3 Press
F10
, and then select [Yes] and press
Enter
.
4 Log on to Windows as an administrator.
5
Click (Start) - [Computer] - [System properties] - [Device Manager], and double-click
[Network adapters] - [Intel(R) 82577LM Gigabit Network Connection], and then click
[Advanced].
Power On by LAN/Wake Up from Wired LAN
To Next Page
Loading...
