Menu operation (continued)
Computer connection guide
You can switch the output signals from COMPUTER1/
COMPUTER2 terminal by pressing the following
computer command keys.
Manufacturer
Image output
selection
command
Panasonic
NEC
NOTE:
The command keys depend on the manufacturers. •
For detailed information, please refer to the instructions
provided with the computers.
If you want to turn off the computer connection guide, select •
SIMPLE or OFF.
OSD DESIGN
You can change the background of the on-screen menu
(OSD).
TYPE1 Semi transparent black
TYPE2 Solid blue
TYPE3 Semi transparent dark blue
WARNING MESSAGE
You can choose to or not to display the warning
messages.
ON
Warning messages will be
displayed
OFF No display
NOTE:
When the • WARNING MESSAGE is set to OFF, use the
projector with utmost care as most of the warning messages
will not be displayed.
▌
STARTUP LOGO
You can set the Panasonic logo, your own image
or Pre-set letters to be displayed at the start of the
projection.
Change setting
Change
setting
Change
setting
Change setting
ON Display “Panasonic” logo
TEXT Display the original text
USER
Display the image registered by the
user
OFF No display
NOTE:
If • TEXT is selected, the input letters are displayed at the
start of the projection. You can display 2 lines of original text
which contains up to 40 characters each.
If • USER is selected, the image transferred by the Logo
Transfer Software is displayed at the start of the projection.
(You can install the Logo Transfer Software from the
provided CD-ROM.)
STARTUP LOGO• will be displayed for 30 seconds.
Manufacturer
Image output
selection
command
lenovo
LG
SONY
To Next Page
Loading...
