Panasonic TQBJ0323-1

Basic operations
24  ENGLISH
Project an image
Preparations
Conrmtheconnectionsoftheperipheraldevices •
(

page 18, 19) and power cord (

page 20).
Switch on the power • (

page 22) to start projecting.
Select the input signal and adjust the image.•
SELECT THE INPUT SIGNAL
1
Switch on the connected devices.
When playing a connected DVD player, if SIGNAL
SEARCH (DISPLAY OPTION menu) is set to
ON, the input signal is detected and projected
automatically when the projector is switched on.
(

page 37)
Set the • INPUT GUIDE (DISPLAY OPTION

ON-SCREEN DISPLAY menu) to DETAILED. If
the projector cannot detect any input signal, the
“Computer connection guide” will be displayed.
(

page 35)
2
Select an input signal.
The image selected with any of the [INPUT
SELECT] button is projected.
NOTE:
Change the settings in the • PICTURE menu according to the
connected device for example DVD, video tape, etc., to be
played. (

page 30)
Conrmtheaspectratioofthescreenandimage.•
Select the optimum aspect ratio. (

page 33)
POSITION THE IMAGE
Whensettinguptheprojectorforthersttimeor
setting up at a new place, you must perform the
following operations.
1
Adjust the vertical angle of the projector.
Place the projector at the right angle from the •
screen.
Press the leg adjuster button • and adjust
the vertical projection angle. Then, adjust the
projected image to the center of the screen.
2
Adjust the projection size and focus.
Turn the zoom and focus rings to adjust the •
projected image.
NOTE:
When you adjust the zoom after adjusting the focus, you •
may need to adjust the focus of the image again.
If the projected image slants to the right or left, turn the rear •
leg adjuster to adjust the angle of the projector.
If keystone distortion occurs, see KEYSTONE. •
(

page 32)
Zoom ring
(ZOOM)
Focus ring
(FOCUS)
Rear leg adjuster