Panasonic TQBJ0323-1 - Page 23

Basic operations
ENGLISH  23
Turn the projector ON or OFF (continued)
TURN THE PROJECTOR OFF
S
T
ANDBY
T
T
(R
)
ON
(
G
)
AU
T
O
S
ET
UP
M
ENU
RETURN
E
N
T
E
R
F
R
E
E
Z
E
A
V
A
A
MUT
E
1
)
2
)
When operating the projector, check the status of the POWER indicator. (

page 21)
1
Press the POWER button.
Aconrmationscreenwillbedisplayed–the
screen will go off and return to projection if there
is no operation for approximately 10 seconds.
2
Press the button again.
The lamp goes off and the projection stops.
The cooling fan continues its rotation and •
POWER indicator lights orange. Wait until the
POWER indicator turns red.
If • STANDBY MODE is set to NORMAL, the
POWERindicatorashesred.(

page 39)
3
Disconnect the power plug from the wall
outlet after the POWER indicator turns red.
(

page 21)
For urgency, you may disconnect the power •
plug immediately since the DIRECT POWER
OFF function is installed.
NOTE:
Conrmthat• CONTROL PANEL (when operating with
the projector body) or REMOTE CONTROLLER (when
operating with the remote control) under CONTROL
DEVICE SETUP in the SECURITY menu is set to ENABLE.
(

page 44)
Power can be turned off by pressing • [POWER] for
at least 0.5 seconds.
POWER indicator