Accessories / Options
8
Assembly screw (4)
M5 × 15
Bracket
●
TBL5ZA32821
Base
●
TBL5ZX0268
Assembly screw (4)
M4 × 25
1
Assembling the pedestal
Use the assembly screws to fasten the bracket to
the base
securely.
●
Make sure that the screws are securely tightened.
●
Forcing the assembly screws the wrong way will strip
the threads.
2
Securing the TV
Use the assembly screws to fasten securely.
●
Tighten the four assembly screws loosely at first, then
tighten them firmly to fix securely.
●
Carry out the work on a horizontal and level surface.
B
Arrow mark
Hole for pedestal
installation
Hold the bracket not
to fall over
D
C
A
Front
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV.
1 Remove the assembly screws from the TV.
2 Pull out the pedestal from the TV.
3 Remove the assembly screw from the bracket.
Preventing the TV from falling over
Using the fall-prevent screw hole and a screw (commercially available), securely fix the body of the pedestal to the installation
surface.
●
The place where the pedestal is to be fixed should be thick enough and made of hard material.
Screw (not supplied)
Diameter: 3 mm
Length: 25 - 30 mm
Screw hole
TC-L42E5H_EN.indd 8TC-L42E5H_EN.indd 8 4/30/2012 8:31:24 AM4/30/2012 8:31:24 AM
To Next Page
Loading...
