Panasonic VL-GM201A - Page 18

18
Introduction and Installation
To attach the power cable
L While pressing on the button with a pointed object such as a screwdriver, insert the power
cable into the terminal connector.
L To disconnect the power cable, press on the button while pulling out.
L To attach an optional power cable, cut off about 12 mm (
1
/2") of the cable cover (1), then
push in firmly until the end of the cable is securely inserted into the power connection
terminal (2).
To attach the wires
L Strip off of the wire cover so that about 9 mm (
3
/8") of the wire is exposed.
L While pressing on the button with a pointed object such as a screwdriver, insert the wire into
the terminal connector.
L To disconnect a wire, press on the button while pulling out.
Monitor station DC terminal
12 Power cable cross section
Button
Terminal connector
Button
Terminal
connector
12 mm
(
1
/
2
")
Correct Incorrect
Button
Terminal connector
GM201A.book Page 18 Monday, April 4, 2005 5:10 PM