5. Additional functions
13
5. Additional functions
Additional functions
5.1 Function settings
You can change the settings, such as Initial settings,
Ringtone settings, and Connected devices settings, to
match how your product is used. You can also view
information on how to access the Operating
Instructions.
1 Press MN. (MN for the sub monitor.)
2 Select the desired item → .
R Repeat this step as necessary to navigate to the
desired setting.
3 Select the desired setting → .
4 Press MN.
5.2 Registering devices
5.2.1 Registering sub monitors (main
monitor and sub monitors only)
1
Main monitor:
Press MN → select “Register/Cancel” →
.
2 Select “Register” → .
R When you are prompted to register your main
monitor, select “Main monitor” → .
3 Select “Sub monitor” → .
4 Select the registration number of the sub monitor to
be registered → .
R Complete the following operations within about 2
minutes.
5 Sub monitor:
R To register a sub monitor for the first time:
Press MN → (OK).
R To re-register a sub monitor:
Press MN → select “REGISTRATION” →
(OK) → (OK).
6 Main monitor:
Press MN.
5.2.2 Registering extension monitors
1
Main monitor:
Press MN → select “Register/Cancel” →
.
2 Select “Register” → .
R When you are prompted to register your main
monitor, select “Main monitor” → .
3 Select “Extension monitor” → .
4 Select the registration number of the extension
monitor to be registered → .
5 Extension monitor:
Press MN → select “Register/Cancel” →
.
6 Select “Register” → .
R When you are prompted to register your
extension monitor, select “Extension
monitor” → → .
7 Select the registration number of the extension
monitor to be registered → .
R Make sure to select the same registration
number that was selected on the main monitor.
R Registration is complete when the extension
monitor restarts.
8 Main monitor:
Press MN.
5.2.3 Registering repeaters
1
Main monitor:
MN → select “Register/Cancel” → .
2 Select “Register” → .
R If you are prompted to register your main
monitor, select “Main monitor” → .
3 Select “Repeater” → .
4 Select the number of the repeater to be registered
→ .
R Complete the following operations within about 2
minutes.
5 Repeater:
While the power is on, press and hold MPROGRAMN
(A) for about 3 seconds.
R The STATUS indicator (B) flashes in green.
R After completing the registration, the indicator
lights up solid.
6 Main monitor:
Press MN.
Note:
R If you register two repeaters, please separate them
more than 3 meters to avoid electrical noise.
R When using devices in separate buildings or over
long distances, cut outs and image distortions may
not be improved even if a repeater is used.
STATUS
IN
USE
(LED)
P
ROGRAM
PROGRAM
A
B
SW274_IIQG.book Page 13 Friday, September 15, 2017 6:34 PM
To Next Page
Loading...
