Panasonic WRKT4504E Series - Page 15

Switching/Blind Actuator
15
Name
Values
Description
Sending feedback
No
Yes,only on change,non-inverted
Yes,cyclical and on change,
non-inverted
Yes,only on change,inverted
Yes,cyclical and on change, inverted
This parameter sets whether the channel status
will be sent to the bus or not. If yes, the feedback
type can be set according to the values. The cycle
time can be set from the General page.
Behaviour at bus failure
Unchanged
ON
OFF
If the bus voltage has failed, then the channel
adopts the status defined here. The same applies
to a complete or partial download of the
application.
Behaviour at mains voltage or
bus recovery
Like before failure
ON
OFF
After restoration of the mains supply or restoration
of the bus supply with the mains voltage present,
the channels revert to the status defined here.
Scene1 reacts to
(from Scene1 to Scene8)
No scene number

These parameters sets the included scenes for
each of 8 scene according to activation number.
For each scene (from scene1 to scene8), there are
64 selection number from scene number 1 to
scene number 64. The scene parameters are active
      

Switching state in Scene 1
(from Scene1 to Scene8)
ON
OFF
This parameter sets the switching state when the
Scene1 is called. (from Scene1 to Scene8)
Permit teach in Scene1
(from Scene1 to Scene8)
No
Yes
This parameter specifies permission for Scene 1
saving after downloading from ETS. (from Scene1
to Scene8)