65
Configure the settings of the servers [Server setup]
The settings relating to the mail server and the FTP server can be configured on this page.
The "Server setup" page has 2 tabs; the [Mail] tab and the [FTP] tab.
Configure the settings relating to the mail server [Mail]
Click the [Mail] tab on the "Server setup" page. (☞ pages 20 and 21: How to display/operate the setup menu)
The settings relating to the mail server used to send the alarm mail can be configured on this page.
[SMTP server address]*
Enter the IP address or the host name of the SMTP
server used to send e-mails.
Number of characters for the SMTP server address:
1 - 128 characters
[POP server address]*
When "POP before SMTP" is selected for "Authentica-
tion", enter the IP address or the host name of the POP
server.
Number of characters for the POP server address:
1 - 128 characters
* Important:
When entering the host name for "SMTP server
address/POP server address", it is necessary to
configure the DNS settings on the [Network] tab of
the "Network setup" page. (☞ page 68)
[Authentication]
Select the authentication method to send e-mails from
the following.
None: It is not necessary to clear any authentication to
send e-mails.
POP before SMTP: It is necessary to first clear the
POP server authentication to use the SMTP server
to send e-mails.
SMTP: It is necessary to clear the SMTP server authen-
tication to send e-mails.
Default: None
Note:
When you don’t know the authentication method to
send e-mails, refer to the network administrator.
[User name]
Enter the user name to access the server.
Number of characters for the user name: 1 - 32 char-
acters
[Password]
Enter the password to access the server.
Number of characters for the password: 0 - 32 char-
acters
[Sender mail address]
Enter the mail address of a sender.
The entered mail address will be displayed in the "From"
(sender) line of the sent mails.
Number of characters for the sender mail address:
3 - 128 characters
To Next Page
Loading...
