Panasonic WV-NS202A - Setting Example of the Router

89
Setting example of the router
This camera transmits MPEG-4 images using UDP protocol.
To display MPEG-4 images using a router, it is necessary to configure the settings (UDP port setup) of both the
camera and the router as below.
Step 1
Configure "MPEG-4 setup" of the camera as follows.
q Transmission type: Unicast port (MANUAL)
w Unicast port1 (Image): 32004
e Unicast port2 (Audio): 33004
Step 2
Configure the router q to which the camera is connected as follows.
Address mapping table
L
O
C
K
O
PEN
Router q
Router w
PC
IP address: 192.168.0.10
IP address: 192.168.0.101
Internet
Step 3
Configure the router w to which the PC is connected as follows.
Address mapping table*
* The address mapping table is the example for when using a typical router.
Depending on the manufacturer of the router, it may be described as "static IP masquerade".
Group
Camera
LAN IP address
192.168.0.10
192.168.0.10
192.168.0.10
LAN port
TCP port: 80
UDP port: 32004
UDP port: 33004
<--->
<--->
<--->
WAN IP address
WAN IP address of the router
WAN IP address of the router
WAN IP address of the router
Protocol
HTTP (TCP port: 80)
UDP port: 32004
UDP port: 33004
Group
PC
WAN IP address
WAN IP address of the router
WAN IP address of the router
Protocol
UDP port: 33004
UDP port: 32004
<--->
<--->
LAN IP address
192.168.0.101
192.168.0.101
LAN port
UDP port: 33004
UDP port: 32004