17
ARJ45 (female) Network cable
Connect an Ethernet cable (category 5e or better) to the network connector.
IMPORTANT:
Use all 4 pairs (8 pins) of the Ethernet cable.
Make sure that the PoE device in use is compliant with IEEE802.3af standard.
When connecting both the 12 V DC power supply and the PoE device for power supply, 12V
DC will be used for power supply.
When the Ethernet cable is disconnected once, reconnect the cable after around 2seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE device.
■ Cables
ARJ45 (female) Network cable
B12 V DC power
supply terminal
CAudio input cable (white)
DAudio output cable (black)
E4P alarm cable
(accessory)
B
2P power
cable
(accessory)
EAlarm input/output cable
Ethernet
cable (category 5e
or better, straight)
12 V DC (red)
GND (black)
FMONITOR OUT terminal
(factory shipment: NTSC monitor)
* This illustration represents WV-S1511LN
To Next Page
Loading...
