21
DSD MOUNT indicator
When an SD memory card is inserted and could Lights off → Blinks green →
be recognized Lights off
When data can be saved after the SD memory card is Lights off → Lights green
inserted and the SD ON/OFF button is pressed
(less than 1 second)
When data can be saved to the SD memory card Lights green
When the SD memory card is removed after holding down
Lights green → Blinks green →
the SD ON/OFF button (about 2 seconds) Lights off (recording)
Lights green → Lights off
(waiting for recording)
When data cannot be saved to the SD memory card Lights off
because an abnormality was detected or the SD
memory card is configured not to be used
ESD ERROR/AF indicator
When AF (Auto Focus) operation is being executed Blinks red (Interval of 1 time/ second)
When the set is being started Lights red
When an SD memory card is recognized normally Lights red → Lights off
When the SD slot is not used or an abnormality is Lights red → Stays red
detected in SD card after the camera has started
Note:
Lighting/blinking LED can be turned off with the software settings at any time. (The initial state is
lighting or blinking.) Set the LED to be solid off if necessary, depending on the installation condi-
tions. (☞ Operating Instructions on the Panasonic support website)
⑴ When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lights
up in green and data can be saved to the SD memory card.
⑵ When the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lights
off and the SD memory card can be removed.
FSD ON/OFF button
GAF button
Used when adjusting the focus. Refer to the Installation Guide for details.
HTELE button
Click the TELE button to adjust the zoom ratio to the “Tele” side.
IWIDE button
Click the WIDE button to adjust the zoom ratio to the “Wide” side.
To Next Page
Loading...
