Panasonic WV-SPN531

16
Before installation
 • Whenmountingthecameratoaceilingor
wall, a ceiling or wall mount bracket must
be separately procured. The size of the
bracket mounting hole is 1/4-20UNC cam-
era tripod mounting hole (depth 9 mm
{11/32 inches}).
 • Anchorboltsandscrewsusedtomount
the camera on the ceiling or wall are not
supplied. Prepare bolts and screws that
match the structure and materials of the
installation location and satisfy the perfor-
mance and reliability specifications shown
below.
<When mounting on a ceiling>
Recommended screw or anchor bolt M6
or M8 x 4 pcs.
Minimum pull-out strength (per 1 pc.)
562 N {126 lbf} (mount bracket: approx.
260 g {0.57 lbs}, camera: 380 g {0.83 lbs},
lens: 70 g {0.15 lbs})
<When mounting on a wall>
Recommended screw or anchor bolt M6
or M8 x 4 pcs.
Minimum pull-out strength (per 1 pc.)
724 N {163 lbf} (mount bracket: approx.
420 g {0.93 lbs}, camera: 380 g {0.83 lbs},
lens: 70 g {0.15 lbs})
* When mounting on either a ceiling or wall,
one M4 screw with minimum pull-out
strength (per 1 pc.) of 24.5 N {5.5 lbf} is
required for the attachment of the safety
wire.
Screw tightening
 • Thescrewsandboltsmustbetightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
 • Donotuseanimpactdriver.Useofan
impact driver may damage the screws or
cause tightening excessively.
 • Whenascrewistightened,makethe
screw at a right angle to the surface. After
tightening the screws or bolts, perform
checks to ensure that the tightening is
sufficient enough so that there is no
movement or looseness.
Protection from lightning
When connecting to a network using the network
cable of this product, observe the following.
 • Whenwiringforthenetwork,designand
engineer not to be affected by lightning.
Radio disturbance
When this product is used near TV/radio
antenna, strong electric field or magnetic field
(near a motor, a transformer or a power line),
images may be distorted and noise may be
produced.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with
IEEE802.3af standard.
Router
When connecting this product to the Internet,
use a broadband router with the port forward-
ing function (NAT, IP masquerade).
Refer to the Operating Instructions on the pro-
vided CD-ROM for further information about
the port forwarding function.
Time & date setting
It is necessary to set the time & date before
putting this product into operation. Refer to the
Operating Instructions on the provided
CD-ROM for descriptions of how to perform
the settings.
Make sure to remove this product if it will
no longer be used.