Panasonic WV-SW598A

Connecting to a network using a PoE+ hub when the temperature is –30 °C {–22 °F} or
less
* When connecting to a network using a PoE+ hub when the temperature is –30 °C {–22 °F} or less, use a 24 V AC power
supply or a tested PoE injector.
Hub, router
PC
LAN cable (category 5e or
better, straight)
LAN cable (category 5e or
better, straight)
Tested PoE injector
LAN cable (category 5e or
better, straight)
Adjustment monitor
(for adjustment use only)
Adjustment monitor
(for adjustment use only)
Powered speaker
Power
ed speaker
Plug-in power type
microphone
Plug-in power type
microphone
Power supply
(24 V AC)
RJ45 female connector
(cable coupler)
RJ45 female connector
(cable coupler)
Recommended total extended
cable length*
<Required cable>
LAN cable (category 5e or better, straight)
*
Recommended cable length from the speaker: less than 10 m {32.8 feet}
Recommended cable length from the microphone: less than 1 m {3.28 feet}
IMPORTANT:
 • Theadjustment monitor usedfor adjustment is used for checking the adjustment of the angular field ofview when
installing the camera or when servicing. It is not provided for recording/monitoring use.
 • Dependingon the adjustment monitor, some characters (camera title, preset ID, etc.) may not be displayed on the
screen.
 • Useaswitchinghuborarouterwhichiscompliantwith10BASE-T/100BASE-TXorbetter.(Whensupplyingthepower
to a hub or router, apply PoE+ (IEEE802.3at compliant).) It is impossible to supply the power to this product from a
PoE hub or router that is compliant with IEEE802.3af standard.
 • IfaPoE+hubisnotused,eachnetworkcameramustbeconnectedtoa24VACpowersupply.
 • Whenusing24VAC,powersupplyfromaPoE+huborrouterisnotrequired.
30