20 TELEMETRY SECURITY-SERVICE SYSTEM PANDORA PROFESSIONAL
be used to heat engine and interior, charge battery or to cool the interior with air
conditioning.
Remote and automatic start can only be used when the system is armed.
If a car has manual transmission, remote or automatic start will only occur if the
program neutral procedure was followed when the car was arming.
Remote and automatic engine start on automatic transmission cars will only
occur, if a transmission selector lever was left in a «P» position. When using the
remote and automatic engine start functions, make sure that a car is secured with
handbrake or some other means of fixating the car on a parking position.
While the system is in remote and automatic start mode, it keeps performing all
security functions of all of the security zones excluding a shock sensor (the system
can be configured to not disable the shock sensor during remote engine start). To
compensate, motion sensor sensitivity and responsiveness will be increased.
If any security zone will be triggered, the engine will be immediately stopped
and alarm mode will be triggered. Herewith all engine blocking functions will be
activated..
Program neutral procedure
(for cars with manual transmission)
If you are planning to use remote and automatic engine start on a car with manual
transmission, before arming you will need to perform following actions:
1. When the engine is running, fixate the car with the handbrake and put gear lever
to the neutral position.
Program neutral procedure will be switched on automatically (it depends on the
system settings) or press and hold button for 3 second to forced switch on this
program.
To Next Page
Loading...
Need help?
General
