57USER MANUAL
mode (the factory preset of the service PIN-code is ‘1-1-1-1’). You can enter the code only if
the base unit is powered, the ignition is switched off, the system is disarmed and the service
mode is switched off. If there is no ‘Service PIN-code’, you can enter the programming mode
using the ‘Secret PIN-code’ written on the owner’s card. After entering the programming
mode, press the VALET button 15 times. Green color of the LED indicator means the radio
tags are enabled, red color means the radio tag are disabled.
Disabling the radio tags:
The LED indicator will light green after entering the programming level. The system
will wait for entering the ‘Secret PIN-code’. Enter the ‘Secret PIN-code’ that is written on
the owner’s plastic card. The system will confirm disabling of the radio tags with two
sound signals of the siren and a long red LED flash
After that, the system will return to the programming menu. If the PIN-code is not
entered within 10 seconds or the input is incorrect, the siren will sound one signal, the
LED will produce the series of red and green flashes and the system will return to the
programming menu.
Enabling the radio tags:
The LED indicator will light red after entering the programming level. The system will
wait for action. Press the VALET button once to enable the radio tags. The system will
confirm enabling with one short sound signal of the siren and a green LED light. After
that the system will return to the programming menu.
To Next Page
Loading...
Need help?
General
