Pantograms GS1501 - Workstation Assembly

To Next Page

To Previous Page

GETTING STARTED

Workstation Assembly

The following components make up the workstation:

(2) Two Side Frames

(1) One Back Support

(1) One Lower Shelf

(1) One Table Top

(4) Four Casters

Assorted fasteners

You will need 5mm and 6mm Allen wrenches and a 12mm wrench or socket for the assembly process.

These tools can be found in the toolbox that was included with your GS1501.

**IMPORTANT - DO NOT TIGHTEN FASTENERS UNTIL ASSEMBLY IS COMPLETE**

Attach Casters

Back Support

Table Tops

Side of Workstation