40
STEP 44
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
• To assemble the LEG CABLE (101) follow the cable routing as shown and use the following steps:
• SECURELY attach the LEG CABLE (101) to the LEG CURL/EXT (15) using one 3/8 X 1-1/4” BOLT (83), one 3/8” WASHER (91), and
one 3/8” LOCK NUT (92). See FIGURE 44.
FIGURE 45
FIGURE 44
• Route the LEG CABLE (101) around the pulleys in the BASE (1) and through the floating pulley as shown in FIGURE 44.
STEP 45
• Run the LEG CABLE (101) through the
hole of the D-RING (7) and attach one
KEYHOLE CLEVIS (66) to the end of
the LEG CABLE (101). See FIGURE 45.
66
1
91
15
101
92
83 3/8 X
1-1/4”
101
101
FLOATING
PULLEY
LAT CABLE
PRESS CABLE
7
101
To Next Page
Loading...
