IMPORTANT NOTES
Please note:
Tools Required for Assembly
* Thank you for purchasing the ParaBody CM3 Gym System. Please read these instructions
thoroughly and keep them for future reference.
* Rubber mallet or hammer
* 3/4” wrench
* 9/16” wrench
* Ratchet with 3/4” and 9/16” sockets
* 5/32” Allen wrench
* Adjustable wrench
* Tape measure
3
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT.
BOLT LENGTH RULER:
* This product must be assembled on a flat, level surface to assure its proper function.
Bolt Length Ruler
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
BOLT LENGTH
* Do not securely tighten any frame connections until the entire frame have been assembled
unless otherwise specified.
To Next Page
Loading...
