PBFS0! EXS00 BASE UNIT ASSEIVIBLY INSTRUCTIONS (STEP #4)
![! WARNING
MAKE SURE SN.A-P HOOKS ARE FASTENED BEFORE DOING ET~]~&CISES.
!t! WARNING !!!
DO NOT OPERATE TId[IS IVIACHINE WITII LAT BA~. OFF SAFETY HOOKS
EXCEPT DURING I-IIGI:! PULLEY EXERCISES. ALSO, LAT BAI’,. _IS NOT
TO BE USED FOR PULL-UPS. ~
!!! ATTENTION USER INSTRUCTION !!!
BEFORE DOING ANY EXERCISES, BE SURE TBAT THE CABI,ES AP,.E
TAUT BY: 1) ADJUSTING THE ADJUST,.,.BLE PRE STRETCH SLID~
DOWN T1R~E ADJIJSTABLX PRE STRETCH S~,tPPORT, AND 2) ADJ-UST!NG
TIlE pRESS ARM. ADJ-0STER SCREW OUT AGAINST TI-IE PRESS AP--~.
THESE TWO .ADJUSTMENTS SHOULD BE MADE AS FAR OUT AS NEIP, D~D
IN ORDER TO PROVIDE SU]F]FICIENT CABLE TIGHTI’~ESS DU~NG
MACHINE USE. 3) I]F HEAD PLATE IS N OT SITTING ON TOP OF
]FIRST WEIGHT STACK PLATE, PLEASE PUSIt I~AD PLATE DOWN
INSERT WEIGHT PIN TO A DESII~D ltESISTAN’CE AND DO A ]FEW
REPS ON ONE O]F TI-1E STATIONS. TItIS WILL "SEAT" TW’~, C.~BLE
S¥STEM~. 4) REPEAT STEPS 1 AND 2"IF NECESSARY.
¯
PLEASE NOTE
w-E RECOIVIIVIEiND CLEA2qfNG YOUR PROD:UCT (PADS AND ]FRAINI-E) ON
REGULAR BASIS, USING x, VAl~f SOAPY WATER. ALSO, TOUCI:I-UP
PAINT CAN BE PURCHASED FR~.)M YO OR PAI~3ODY DEALER, OR ]FROM
YOUR PARABODY CUSTOMEK SERVICE Rv~PRESENTAT .IYE AT:
1-800-328-9714
14
To Next Page
Loading...
