HS Consumer Treadmill
How To…Replace The Motor Controller
Tools Required: Phillips Screwdriver (All fasteners are metric. Make sure that you have metric tools.)
Section 3
15
REMOVAL AND INSTALLATION
1. At the power switch, turn off the unit,
then unplug the power cord at the wall
outlet.
2. Remove the motor cover front screws
(4) of the motor cover, lift off the motor
cover.
3. Disconnect all electrical connectors
from the motor controller
board.( Please refer to WIRING
DIAGRAM – Section IV, page 9)
4. Remove the power switch, AC inlet
and circuit breaker by removing the
power AC inlet screws(2)
5. Remove the controller screws(4) and
lift out the motor controller from the
frame.
6. Install new motor controller in reverse
order.
7. Make sure to calibrate incline motor.
To Next Page
Loading...
