Paradox PCS200

Page 16
Configuring the PCS200
Configuring GSM Network Provider Information
To connect the PCS200 to the GPRS network, certain registration parameters
must be set (supplied by your GSM network provider). These parameters
include the Access Point Name, APN User Name, and the APN Password. To
begin the configuration of your GSM network provider information, enter the
section programming in your panel.
Note: When entering into GSM network provider sections, the LCD screen of the
control panel’s keypad will display either “Labels” or “Messages”.
Configuring WinLoad Access
The PCS200 Communicator Module provides remote access for upload and
download with WinLoad via a GPRS connection. The following site specific
sections must be configured for WinLoad access.
Note: In the case where a reportable event occurs while a WinLoad session is
active via GPRS, the communication is terminated to allow event reporting.
MG/SP/E EVO Feature Details
[921] [2960] APN part 1
(characters 1 - 16)
This information can
be obtained from your
GSM network
provider.
[922] [2961] APN part 2
(characters 17 - 32)
[923] [2962] APN user name part 1
[924] [2963] APN user name part 2
[925] [2964] APN password part 1
[926] [2965] APN password part 2
MG/SP/E EVO Feature Details
[920] [2966] Software port Default: 10000
[927] [3013] Installer software password Default: admin