Page 21
Configuring the PCS200
Refer to the control panel programming guide for information about entering
special characters.
Arm/Disarm System via Text Message (GSM only)
It is possible to arm or disarm your system by sending an SMS text message
from any cell phone. The message must be sent to the PCS200’s phone
number, as determined by the cell phone network provider. The text message
command has a specific format and specific elements that must be sent to the
phone number of the PCS200 module. The format is as follows:
SMS Text Message Format
C[USER CODE].[ACTION].A[PARTITIONS].[PHONE NUMBER]
Examples
Arming example - C1234.ARM.A5.5555551234
Disarming example - C1234.OFF.A5.5555551234
Multiple partitions - C1234.ARM.A1,3,5TO7.5555551234
List of SMS Commands
The following table provides a listing of all SMS commands.
P[password].A.[IP address].P[port number] Used for GPRS remote
access
P[password].IP.[call back phone number] Used to obtain the IP
address of the PCS200
P[password].RESET Used to reset the PCS200
P[password].BWS.ON Used to enable bandwidth
saver mode
P[password].BWS.OFF Used to disable bandwidth
saver mode
P[password].VOLOUT.[GSM output volume]] Used to set the GSM output
volume; values range
between 85 to 100
To Next Page
Loading...
Need help?
General
