Paradox PCS200

Page 25
Module Supervision Options
End User SMS Programming
With Master Programming, you can:
• Set which phone numbers (up to 8 with MG/SP/ E-Series or 16 with
Digiplex EVO) will receive text messages sent by the PCS200 to report
system events.
• Select from which area the PCS200 will send text messages (per phone
number).
• Select which event groups (alarm, arm/disarm, trouble and trouble
restore) will generate text messages.
End User SMS Programming with Digiplex EVO
1) Enter the control panel [MASTER CODE] then press [0] to access Master
Programming.
2) Press [1] to enter the SMS settings menu.
3) Select which phone number you wish to program ([01] to [16]).
4) Enter or modify the phone number - up to 32 characters. To go to the
next screen press [
ENTER].
5) Select which partitions are enabled for that SMS number by enabling
options [1] to [8]. Press [
ENTER] to go to the next screen.
6) To select which events generate an SMS message, enable or disable
options [1] to [4].
7) To save press [
ENTER].
8) After saving or in the main SMS settings menu press [] to see which
SMS numbers ([01] to [16]) are programmed. To program the SMS
number currently displayed, press [
ACC].
End User SMS Programming with MG/SP / E-Series
1) To access Master Programming, press the [] key.
2) Enter [
MASTER CODE].
3) To enter SMS Setup, press [
ARM].
4) Using the [] and []* or [
STAY] keys, select one of the eight telephone
numbers you wish to program and press [
ENTER].
*With K10LEDV/H or K636 keypads, use [SLEEP] for [] and [STAY]
for [].
5) Enter or modify the phone number - up to 32 characters. To go to the
next screen press [
ENTER].
6) Select the SMS Event Call Options you wish to apply to the telephone
number.
7) To save press [
ENTER].
8) Select which areas are assigned to this telephone number. To save,
press [
ENTER].