Sensor Events
Sensor Events header. Up to 32 sensor events can be programmed. A sensor event can
be assigned to either channel. Each sensor event can be assigned to any day or combi-
nation of days including the 3 holiday schedules (A, B and C). Use the NEXT key to begin
programming.
The +/- keys will quickly step through the sensor events when the event # is flashing.
Select the sensor number, select the channel and program the hours and minutes while
each of these parameters are flashing. When a sensor number is shown, its sensor type
(F,C,L or U) is also shown. If the input is not configured as a sensor a question mark (?) is
shown.
Select YES for each day that is to be included in this sensor event.
Program the turn on setpoint.
Program the turn off setpoint.
28
To Next Page
Loading...
