RUN
The RUN mode is the normal operating mode. In the RUN mode the current time and day
are shown. If today is a holiday, the active holiday schedule is also shown. Channel status
is shown on the bottom line. The channel number is shown if that channel is on. If the
channel number is flashing, that channel is currently overridden. If it is flashing mostly on,
the channel is overridden on. If it is flashing mostly off, the channel is overridden off. The
input # is also shown along with the status of that input. The following is a list of the possi-
ble input status messages:
Message Input Config. Status
NONE not config --
On\d On\d input closed
OFFd On\d input open, in delay
-N- On\d not active
OVd OVR overridden on w/delay?
-V- OVR not active or overridden on or off without delay
ENb ENb input closed (enabled)
dISb ENb input open (disabled)
072F sensor, F sensor value
LO F sensor, F sensor value below range
025C sensor, C sensor value
HI C sensor, C sensor value above range
055L sensor, L sensor value
175U sensor, U sensor value
33
To Next Page
Loading...
