5. Emergency CPR (back-lowering) function
When using the emergency CPR function, make sure that the patient's and/or user's head, arms,
feet or other body parts have not entered the gap between the back section base and the frame.
There is a risk of getting caught, resulting in injury.
<Emergency CPR function procedure>
①Place one hand on the side of the back section
base and pull the emergency CPR lever.
Levers are located at both sides of the bed under
the back section base and either lever can be used.
②Keep pulling the lever until the back section base
returns to flat status.
In case of an emergency or a power failure, the raised back section base can be quickly returned to
Do not stop the back-lowering operation halfway through. This may cause malfunction of the bed.
●Do not use the emergency CPR lever to raise back section base.
●Do not operate the bed while holding on to the emergency CPR lever.
After operating emergency CPR function,
firstly press the [↓] button of the back raise
adjustment buttons on the handheld
controller or the side-rail integrated panel
for more than 5 seconds in power on status.
To Next Page
Loading...
