Load capacity is 76kg. Do not hang an article exceeding the load capacity because it may damage
the lifting pole, resulting in injury.
●During transportation, do not hang on to the lifting pole. It may tip over the bed, the patient on the
bed may fall off the bed, resulting in injury.
●Do not detach the headboard when lifting pole is attached, or the head or neck enters the gap
between the side-rail and the lifting pole, and there is a risk of injury.
The lifting pole can be used for support to raise the body from the bed by attaching to the bed. It can
be used for training too.
Attach the parts of the lifting pole to the bed as shown in figure. The parts can be attached on
both the right side and the left side of the bed.
②Inset the arm into the outer pipe and attach the grip to the arm.
③Tighten the knob bolt to fasten the arm. The arm can be set in three positions as shown in figure by
changing the knob bolt positions.
④Pull down the grip to make sure that the lifting pole is attached firmly.
For any queries, please feel free to contact Paramount Bed or your distributor.
Parts of the lifting pole
To Next Page
Loading...
