Parker H Series - Page 13

H Series Fieldbus DeviceNet Adapters, Series A (PSSCDM12A, PSSCDM18PA) E101P
4
Set the Node Address
Valid node addresses are 00 through 63.
Set the node address using either the rotary switches, RSNetWorx for
DeviceNet™, DeviceNetManager™, or another software configuration
tool. Setting the switches at any number from 64 through 99 lets the
software have address control.
Each module is shipped with the switches set for node address 63.
Remove the caps on the front of the module to access the switches
(refer to the illustrations on page 1). The two switches are:
 • X10(mostsignicantdigit)–leftsideofmodule
 • X1(leastsignicantdigit)–rightsideofmodule
To reset the node address, use a small blade screwdriver to rotate
the switches. Line up the small notch on the switch with the number
setting you wish to use and then cycle power.
The rotary switches are read periodically. If the switches have been
changed since the last time they were read and they no longer match
the on line address, a minor fault will occur, which is indicated by a
flashing red Adapter Status LED. Settings of 64 through 99 cause
the module to use the last valid node address stored internally.
Example: The last setting internally was 40. If a change is made to
68, and then you power up, the address will default to 40.
The module is equipped with AutoBaud detect. AutoBaud lets the
module read the settings already in use on your DeviceNet network
and automatically adjusts to follow those settings.
EDS File Requirements
The EDS files are available online at www.parker.com/pneu/
hseriesfieldbus
OpenCongurationMethod
For using H Series Fieldbus DeviceNet Adapters without
RSNetWorx™ or RSLogix™ 5000, refer to document “User Guide:
Configuration of the H Series Fieldbus™ Pneumatics Platform using
CIP™ Explicit Messaging", which is available online at www.parker.
com/pneu/hseriesfieldbus
This example shows the
node address set at 63.