Parker H Series - Page 14

H Series Fieldbus DeviceNet Adapters, Series A (PSSCDM12A, PSSCDM18PA) E101P
5
Wire the DeviceNet Adapters
Following are wiring instructions for the DeviceNet Adapters.
Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP67
requirements.
!
ATTENTION
Male In Connector
PSSCDM12A(MicroM12A-CodingKey)
Female Out Connector
(view into connector)
Pin 1 - Drain
Pin 2 - +V
Pin 3 - -V
Pin 4 - CAN_High
Pin 5 - CAN_Low
Male In Connector
PSSCDM18PA (Mini 7/8")
Female Out Connector
(view into connector)
Pin 1 - Drain
Pin 2 - +V
Pin 3 - -V
Pin 4 - CAN_High
Pin 5 - CAN_Low
Male In Connector
DeviceNetAuxiliaryPower(Mini7/8")
(view into connector)
Pin 1 - User Power +
Pin 2 - Adapter Power +
Pin 3 - Adapter Power -
Pin 4 - User Power -
NOTE: User power is the 24VDC power for field devices.
Adapter power is the 24VDC power for adapter. It is converted to
5VDC to power H Series Fieldbus modules.