Parker H Series - Page 30

H Series Fieldbus ControlNet Adapter, Series A (PSSCCNA) E103P
5
Wire the ControlNet Adapter
Following are wiring instructions for the ControlNet Adapter.
TNC Cables
 • ConnectTNCcablestoChannelAorBforsinglemedia.
 • ConnectTNCcablestoChannelAandBforredundantmedia.
Make sure all connectors and caps are securely tightened to
properly seal the connections against leaks and maintain IP67
requirements.
!
ATTENTION
Male In Connector
PSSCCNAAuxiliaryPower(Mini7/8")
(view into connector)
Pin 1 - User Power +
Pin 2 - Adapter Power +
Pin 3 - Adapter Power -
Pin 4 - User Power -
NOTE: User power is the 24VDC power for field devices.
Adapter power is the 24VDC power for adapter. It is converted to
5VDC to power H Series Fieldbus modules