Parker H Series - Page 317

Publication PSS-UM001A-EN-P – December 2016
Confi gure the DeviceNet Scanner Subnet 4-3
Click Advanced to change the
advanced module settings, as
shown in the following window.
Module window
Set the Interscan
Delay here.
Set the
Foreground
to Background
Poll Ratio here.
Click here to reset
the Interscan
Delay and
Foreground
to Background
Poll Ratio back
to the module
default values.
Advanced window accessed from
Module window
We recommend you DO NOT
change module settings unless
advised to do so by a Rockwell
Automation support representative.
Set the Expected
Packet Rate here.
Click OK to accept
new settings.
Set the number of
Transmit Retries here.
Choose
Electronic Key
parameters for
each module.
Add modules to,
or remove modules
from, the scanlist.
Scanlist window
Add and remove
I/O modules to and
from the scanlist
on this screen.
To set any of the
parameters on
this screen,
(e.g., Node Active)
for a specific
module, first add
the module to the
scanlist and then
highlight the
module to make
specific changes.
Click Automap
on Add so a
checkmark appears
to automap I/O data
when adding
modules.
Click Edit I/O
Parameters to edit
the module's I/O
parameters, as
shown below.
Click on the
appropriate I/O
data transmission
method (e.g.,
Polled) and make
other appropriate
I/O parameter
changes on
this screen.
Click OK when finished.
Edit I/O
Parameters
window accessed
from Scanlist
window