Parker H Series - Page 318

Publication PSS-UM001A-EN-P – December 2016
Use this pull-down
menu to choose a
Memory type.
The memory type
corresponds to an
I/O connections
on DeviceNet.
Highlight a module
and click Unmap
to unmap it.
Click Advanced to
edit the advanced
mapping parameters,
as shown below.
Click Options to
edit the automap
options, as
shown below.
Set the starting byte
for I/O mapping.
Input window
4-4 Confi gure the DeviceNet Scanner Subnet
Set Map From
parameters here.
Set Map To
parameters here.
Click Apply
Mapping to apply
changes and leave
screen open.
Click Close
when finished.
Advanced
Mapping window
accessed from
Input window
Choose a Data Alignment
and click OK.
Automap Options window
accessed from Input window
Use this pull-down
menu to choose a
memory type. This
corresponds to I/O
on the primary
DeviceNet.
Set the starting
byte for I/O
mapping here.
The bytes mapped
last will determine
sizes on the
primary DeviceNet.
Output window
Highlight a module
and click Unmap
to unmap it.
Click Advanced to
edit the advanced
mapping parameters.
Click Options to
edit the automap
options.
Note that the Advanced Mapping
and Options windows are the same
for output modules as those shown
for input modules. See above for
an explanation of these windows.