Parker H Series - MAINTENANCE; H Series Screwed Head;Bonnet Maintenance

If your RSLogic 5000 is Version 13.X:
 •Highlightthe1738-ACNR under I/O configuration, right click and
select NewModule.
 •ChoosetheGeneric 1738 module from the list of Allen-Bradley
modules.
 •Enter a name (optional), an appropriate slot number and the
connection parameters as shown in this screen capture.
 •ChooseNext to set RPI.
 •ChooseFinish. Notice that the 32 Point Valve Driver Module is
now under the I/O configuration.
Step4: DownloadtheProgramtotheControllerand
 CongurethePSSCCNAor1738-ACNRAdapter.
 •Reference pages 4-11 through 4-15  of Rockwell publication
1734-UM008 for similar setup procedure.
Step5: ScheduleI/OModuleConnections
 •Reference pages 4-15 through 4-19  of Rockwell publication
1734-UM008 for similar setup procedure.
Step6: AccessModuleDataviathePSSCCNAor1738-ACNR
Adapter.
 •Makesurethe32outputsofPSSV32AappearinControllerTags.
Use the information in the ladder logic program to access module
data.
 •Referencepages4-19through4-22ofRockwellpublication
1734-UM008 for similar information.
Setupthe32PointValveDriverinEtherNet/IP
Step1: Load32PointValveDriverEDSletoRSLinx
 •DownloadEDSlefromwww.parker.com/pneu/hserieseldbus
• Onyourcomputer,followStart➔RockwellSoftware➔RSLinx
Tools➔EDSHardwareInstallationTool to load the EDS file to
RSLinx
Step2: SetIPAddressforEtherNet/IPScannerandAdapter
 •Set IP address using Rockwell BootP/DHCP utility for
EtherNet/IP scanner and PSSCENA or 1738-AENT adapter.
Reference pages 3-7 through 3-10 of Rockwell publication
1734-UM011 (follow www.rockwell.com➔Support➔Support
Overview➔Online manuals and literature➔I/O➔1734 POINT
and 1734D POINT Block I/O and find POINT I/O Ethernet
Adapter User Manual) for similar information.
Step3: AddEtherNet/IPScannerandAdaptertoRSLogix
 5000I/Oconguration.
 •AddEtherNet/IPscannerandPSSCENAor1738-AENTadapter
to I/O configuration. Reference pages 4-4 to 4-8 of Rockwell
publication 1734-UM011 for similar information.
Step4: Add32PointValveDrivertoRSLogix5000
 I/OConguration.
If your RSLogic 5000 is Version 15.X or greater:
 •HighlightthePSSCENA under I/O configuration, right click and
select NewModule.
 •ChoosethePSSV32A module from the list of Parker modules.
 •Enteraname(optional)andclickOK.
Notice that the 32 Point Valve Drive Module is now under I/O
Configuration.
H Series Fieldbus 32 Point Valve Driver, Series A (PSSV32A) E100P
5