Parker Helac PowerTilt Series - Page 36

PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
36
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
7. Using a hoist or similar lifting device, lift o
the standard pin-on coupler (06) or feet (6.1,
6.2).
NOTICE
There is an alignment dowel pin
(105) between the shaft and
the torque foot (6.1) to prevent
sliding.
5.
Tighten the two lock ring set screws (129)
into the lock ring (05). Turn the set screws
equally, backing the lock ring o the end cap
(04) and idler foot (6.2).
6.
Insert threaded bolts into the lock ring (05)
and pull straight out.
Disassembly
Standard Pin-on Coupler Removal