PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
47
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
1. Before installing the shaft (02), coat the shaft
with high quality hydraulic oil.
NOTICE
Temporarily cover the shaft
threads with tape to prevent seal
damage. Remove the tape after
the shaft has been installed.
2.
Insert the shaft (02) into the piston sleeve
assembly (03), carefully aligning the timing
marks on the shaft with the piston (03). Take
care not to damage the I.D. piston seals (204,
205) with the threaded end of the shaft.
4. Use a pry bar to rotate the shaft (02) in until it is
completely bottomed out in the housing (01).
3.
Verify timing marks before rotating the shaft
all the way into the housing (01).
Assembly
Shaft Installation
To Next Page
Loading...
