Parker Helac PowerTilt Series - Seal and Bearing Removal

PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
40
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
1. Use the seal tools to remove all seals, wear
guides and thrust washers (344) from the
piston sleeve assembly (03), end cap (04) and
shaft (02).
Note that several product models may not
have wear guides on the I.D. and/or O.D. of
the piston sleeve assembly (03).
NOTICE
Replace all seals, bearings and
thrust washers (344) as required.
2.
Remove the grease fittings (122), grease
relief covers (107) and grease reliefs (123).
Disassembly
Seal and Bearing Removal