PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
43
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
2. Lightly coat both sides of the thrust washer
(344) with lithium grease and install on the
thrust face of the end cap (04).
3. Next install the O.D. pressure seal (238) with
the lip facing inboard toward the hydraulic
pressure.
4. Then install the wear guides (340, 341) in the
wide groove of the end cap (04).
5.
Now install the O-ring (230) and
backup ring (231) into the I.D. seal
groove on the end cap (04).
Assembly
Seal and Bearing Installation
To Next Page
Loading...
