Parker Helac PowerTilt Series - Page 45

PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
45
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
4. Now install the wear guides (340, 341).
2. Lightly coat both sides of the thrust washer
(344) with Lithium grease and install onto the
shaft (02).
3. Then install the pressure seal (238) with the lip
facing inboard, toward the hydraulic pressure.
Shaft Seal and Bearing Installation
1. First install the exclusion seal (237) onto the
shaft (02).
Assembly
Seal and Bearing Installation