Parker Helac PowerTilt Series - Page 52

PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
52
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
9. Coat the lock ring screw (120) threads
with Loctite 242, install and torque per the
Fastener Torque Chart on Page 42.
10. Coat the lock ring set screws (129) with
Loctite 545, thread until tight and torque to
(41 Nm).
7. Install the lock ring O-ring (239) onto the shaft.
8. Next install the lock ring (05) using two
threaded bolts as handles.
Assembly
Standard Pin-on Coupler Installation