Parker Hannifin Corporation
Hose Products Division
Wickliffe, OH
6
Technical Manual
Karrykrimp
Bulletin 4480-T30-USBulletin 4480-T30-US
1. Remove crimper and all accessories from shipping
crate. Verify that you have received the following
items:
• Crimp Head 82C-CHD
• Silver Die Ring 82C-R01
• Black Die Ring 82C-R02
• Hose Assembly 85C-00L
• Stand Assembly 85C-STD
• Technical Manual 4480-T30-US
• Grease
• Training DVD
2. Assemble crimper base unit to stand as shown in
Figure 2. Place machine on sturdy bench. It is
recommended that the machine be bolted to the
bench. Two 1/2” holes are provided in the stand for
this purpose. Make sure crimper base overhangs
bench to allow access from below base plate.
3. Connect hose assembly to power unit and to
crimper cylinder. Follow instructions supplied with
power unit for venting, checking oil level, or general
usage.
4. Place die ring in position on crimper base. Cycle
cylinder up and down a few times to purge air from
system. Recheck oil level in power units. Make
sure cylinder is fully retracted before adding any
hydraulic oil.
5. Your machine is now ready for use. Please read
the remainder of this manual before proceeding to
crimp any hose assembly. Crimping instructions
can be found on Page 10.
Installation and Operation 82C-061L
Figure 2
www.comoso.com
To Next Page
Loading...
