Parker PA Series - Page 24

Page 24
Figure 28. Operating sequence CAL USER
NOTE: Write down the current changing value before recording. The changing value to be recorded may be different than the
value after being recorded. If the deviation between the two values is less than 3, the recorded value can be used, otherwise,
please run the calibration for the related value again.
CAL FACT
RUN
Calibration values reset to factory settings
Press for approx.3s
CAL POS
ENT
EXIT
OK
SET
MIN 0
MIN 0
OK
SET
MAX 0
MAX 0
CAL INPUT
ENT
EXIT
OK
SET
4mA 0
4mA 0
OK
SET
20mA 0
20mA 0
CAL USER
ENT
EXIT
CAL POS
CAL INPUT
CAL FACT