Parker RAC Europe PSD04 | User manual ver. 3.6 | Code 144PSDI364
Page 10 of 74
3.2 Installation
On DIN rail 35.0 x 7.5 mm (1.377 x 0.295 in) or 35.0 x 15.0 mm (1.377 x 0.590 in).
To install the device operate as shown in the following drawing.
1 2
To remove the device remove possible extractable screw terminal blocks plugged at the bottom first, then operate on
the DIN rail clips with a screwdriver as shown in the following drawing.
3 4
To install the device again press the DIN rail clips to the end first.
3.3 Additional information for the installation
- make sure the working conditions of the device (operating temperature, operating humidity, etc.) are in the
limits indicated; look at chapter 11 “TECHNICAL DATA”
- do not install the device close to heating sources (heaters, hot air ducts, etc.), devices having big magnetos
(loud speakers, etc.), locations subject to direct sunlight, rain, humidity, dust and mechanical vibration
- according to the local safety legislation, protection against possible contacts with other electrical parts must be
ensured by the correct installation of the device; all the parts which ensure protection of the device must be
fixed so that you cannot be removed without using a special tool.
To Next Page
Loading...
