Parker RAC Europe PSD04 | User manual ver. 3.6 | Code 144PSDI364
Page 34 of 74
3. Press and release button UP or button DOWN to select the submenu.
4. Press and release button ENTER.
To gain access a protected submenu operate as follows:
5. From step 2.1 or step 2.2, press and release button UP or button DOWN to select the submenu.
6. Press and release button ENTER.
7. Press and release button ENTER again to set the password value.
8. Press and release button DOWN over and over again to set ā-19ā.
9. Press and release button ENTER again.
To modify a parameter operate as follows:
10. From step 4 or step 9, press and release button UP or button DOWN to select the parameter.
11. Press and release button ENTER.
12. Press and release button UP or button DOWN to modify the value.
13. Press and release button ENTER to confirm the value.
14. Press and release button ESC over and over again to go back to the previous pages.
To quit the procedure operate as follows:
15. Press and release button ESC over and over again: possible modifications will not be saved.
7.7 Backup and restore
If the version of the driver EVdrive03 is appropriate, it is possible to connect a keyboard V-graph that displays the
pages backup / restore which permit to save a copy of the memory areas of the parameters. The copy can be done in
another area of the EEPROM or in an external memory (parameters key) connected to the communication
programming port.
It is possible to save both the application parameters (EVDrive03 parameters), both the driver parameters (calibration
network settings, ...).
It is possible to restore the parameters from copies in the memory (restore application or driver parameters) or load
the default parameters (load default configuration from flash memory).
The backup and restore functionalities are active only in Stand-by off (10).
To Next Page
Loading...
