Parker SciLog LabTec - Page 24

24


Documentation
The LabTec™ will output data to a printer or a PC at the completion of each dispense for archival
purposes. The following is an example of that data, and the abbreviations used.
09/24/09; 16:42; LABT 0.11X; Weight; CW; Tubing=15; Units=psi; Exec 1; Weight set= 100.00G ;
Count= 1; Rate= 80.0%;
Slow Factor = 25.00; Sniffle = 0.00; Alarms:HP=1; HT=1; Limits; HP=20.0; HT=35.0;
MT, SC, DW, CW, P1, T, ST,
16:43:01, 1, 100.00, 100.0,
--.-, 0.0, FINISH,
16:43:13, 2, 100.10, 200.1,
--.-, 0.0, FINISH,
16:43:24, 3, 100.00, 300.1,
--.-, 0.0, FINISH,
MT = Military Time
SC = Sample #
DW = Dispensed Weight
CW = Cumulative Weight,
P1 = Pressure
T = Temperature
ST = Status
The following chart shows tubing dimensions and the available flow rates based on tubing, pump
head and motor size choices:
Tubing Size 13 14 16 25 17 18 15 24 35
Tubing ID*: in
0.030 0.60 0.125 0.190 0.250 0.310 0.190 0.250 0.310
Tubing OD*: in
0.157 0.189 0.251 0.314 0.376 0.439 0.376 0.439 0.500
Tubing Wall*: in
0.063 0.063 0.063 0.063 0.063 0.063 0.093 0.093 0.093
Pump Rate Range*:
mL / min mL / min mL / min mL / m in mL / min mL / m in mL / min mL / min mL / min
CP-8 8RPM
0.03 - 0.45 0.10 - 1.63 0.43 - 6.38 0.9 - 12.6 1.14 - 18.3 1.7 - 24.3 0.45 - 13.0 0.65 - 20.0 NR
CP-120 160RPM
0.5 - 10.0 1.7 - 35.2 6.3 - 129.0 12.5 - 283.0 18.5 - 405.0 24.7 - 554.0 9.0 - 260.0 13.0 - 435.0 NR
CP-200 600RPM
2.0 - 34.0 8.6 -132.0 29.0 - 533.0 49.0 - 974.0
70.0
-1048.0
103.0
-1515.0
59.0 - 993.0 85.0 - 1348.0
111.0 - 2258.0
*Nominal Values
Pump Head Model: 1081 1082